Books

The Science of Homeopathy – page 157

sakoff method is preferable.

Hahnemann’s original potencies were made in alcohol, but this again places a great burden upon pharmacies producing high potency remedies. Since alcohol cannot be re-used, tremendous volumes of al- cohol would be required to make a high potency remedy. For example, consider the production of a 10,000 potency; to make such a potency would require approximately 50 liters of alcohol – an expensive propo- sition! It is unlikely that water or alcohol will make any difference in the actual process of potentization, as various mixtures of both have been used successfully in the past. It would therefore be preferable to use double-distilled water for all of the intermediary potencies. Any potency, however, which is to be stored for use as a remedy should be preserved in pure alcohol. Water is not a good medium for pres- ervation because microorganisms tend to grow over time and might interfere with the action of the remedy. Alcohol, on the other hand, is an excellent preservative and can be relied upon to maintain potencies indefinitely.

In any case, careful attention should be paid to the standards of purity of all materials being used in this delicate process. As can be imagined, even small amounts of contamination can be exaggerated tremendously during potentization. Therefore, the environment in which potentizing machines are used must be as free as possible from dust, chemical odors, sunlight, etc. The vials used should be of high chemical standards. The water and alcohol used must be at least of high chemical standards and then at least double-distilled into even greater purity. The tops of the vials used, from experience, should be made of cork (or at least lined by cork), and the cork should be of high quality. The milk sugar used in trituration and for administration of remedies should be of high quality, and the mortar and pestle used should be heated to high temperatures before preparing each remedy.

 

Nomenclature

 

Terminology used in naming potencies on different scales has evolved over time. Unfortunately, it has led to conventions which are slightly confusing to the beginner.

The decimal scale is based on dilution of 1/10. The first 1x potency is a 1/10 dilution. The second dilution (1/10×1/10 = 1/100) is called a 2x potency. The eighth decimal dilution 1/10 x 1/10 x 1/10 x 1/10 x 1/10 x 1/10 x 1/10 x 1/10 x = 1/100,000,000) is called the 8x potency. Thus, the potency on the decimal scale is equivalent to the number of zeros in the denominator of the final dilution.